MATSONIC MS-5120 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Cartes mères MATSONIC MS-5120. MATSONIC Motherboard MS-5120 Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 28
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
RADAR II 2.48 Release Notes Page 1 of 28 Rev B: October 16, 2000
RADAR II System Software - Version 2.48
Operating System Considerations:
If you plan to install more than 64 MB of memory in your RADAR unit, you will need to install the operating
system patch which can be found on the Download page in the Support section of the web site. The patch
is independent of the RADAR II System Software and only has to be installed once on each RADAR unit.
See Appendix II: RADAR II 64MB Patch for details.
Hardware Considerations:
To fully utilize the features in version 2.48, you may need to upgrade your RADAR II unit as follows:
1) Ensure that your RADAR II system has sufficient memory (RAM) installed on the motherboard to
support the disk drives that you have installed (or are planning to install). See Appendix III: Approved
SCSI Disk Drives for the list of available drives and their capacities. You will need a minimum of 64 MB
of RAM if you plan to use the waveform display feature. See Appendix I: System Memory
Requirements and Appendix VI: Upgrading System Memory for details.
2) Waveform display also requires that a high-speed processor be installed on the motherboard. The Intel
Pentium 233MHz MMX P55C processor is recommended. Refer to Appendix VII: Upgrading the
System Processor for details.
3) In rare circumstances, certain Exabyte Eliant 820 tape drives experience a firmware fault that can cause
a backup operation to fail. Should this occur, contact tech support for instructions on upgrading your
tape drive or turning off the backup optimization feature. For more information about tape drives and
DVD RAM drives, refer to Appendix V: Approved Backup Devices.
4) Additional dedicated keys were implemented on the RE-8 II remote control for version 2.07. If you have
not yet upgraded your RE-8 II, refer to Appendix VIII: RE-8 II Remote Control Key Map for the key
locations.
Waveform Display Considerations:
When you upgrade your RADAR II system to Version 2.48, you must also upgrade all of your audio
drives to 2.48 format. However, for each drive (or set of drives if you chain external drives to your
RADAR), you may choose whether or not to display waveforms. Some of the steps in the Upgrade
Procedure require you to perform different actions for drives that will display waveforms. If you have not
previously converted your audio drives to waveform mode, you may do so during the upgrade by
following the steps “for audio drives that are being converted from non-waveform to waveform mode”. If
you already converted to waveform mode in a previous version or if you will not be using waveforms in
version 2.48, follow the steps “for other audio drives”. You may later reinitialize drives to turn waveforms
on or off as detailed in the instructions for “Turning Waveforms On” and “Turning Waveforms Off”.
Note that *.WAV files imported from a floppy disk will not display waveforms on RADAR.
Due to memory limitations, waveforms are only displayed for audio that is in the first 4 to 5 hours of the
24 hour window.
Vue de la page 0
1 2 3 4 5 6 ... 27 28

Résumé du contenu

Page 1

RADAR II 2.48 Release Notes Page 1 of 28 Rev B: October 16, 2000 RADAR II System Software - Version 2.48 Operating System Considerations: If you

Page 2 - Upgrade Procedure:

RADAR II 2.48 Release Notes Page 10 of 28 Rev B: October 16, 2000 MAIN/PREFS MENU: DEF SMPTE FIELD SHOW SUBFRAMES DEF

Page 3

RADAR II 2.48 Release Notes Page 11 of 28 Rev B: October 16, 2000 TDIF MENU IN SAMPLE POINT INPUT MODE Special mod

Page 4

RADAR II 2.48 Release Notes Page 12 of 28 Rev B: October 16, 2000 Bugs Fixed Since Version 2.06: 206C / 839 Play in RADARlink solo mode plays s

Page 5

RADAR II 2.48 Release Notes Page 13 of 28 Rev B: October 16, 2000 829 Wiping an unused disk ID causes General Protection Fault When using the “WI

Page 6

RADAR II 2.48 Release Notes Page 14 of 28 Rev B: October 16, 2000 849 Allow long recordings to be dissected into small segments When a recording

Page 7

RADAR II 2.48 Release Notes Page 15 of 28 Rev B: October 16, 2000 863 SMPTE display out by .05 frames after recording in RADARlink mode After re

Page 8 - RADAR Menu Structure

RADAR II 2.48 Release Notes Page 16 of 28 Rev B: October 16, 2000 Bugs Fixed Since Version 2.13: 547 RADARlink slave won’t copy proje

Page 9

RADAR II 2.48 Release Notes Page 17 of 28 Rev B: October 16, 2000 Bugs Fixed Since Version 2.14: 883 General Protection Fault during clipboar

Page 10

RADAR II 2.48 Release Notes Page 18 of 28 Rev B: October 16, 2000 216A / 895 Multiple disk operation failure – backup / restore When attempting

Page 11

RADAR II 2.48 Release Notes Page 19 of 28 Rev B: October 16, 2000 Bugs Fixed Since Version 2.18: 218A / 908 Waveforms missing when restoring R

Page 12

RADAR II 2.48 Release Notes Page 2 of 28 Rev B: October 16, 2000 Upgrade Procedure: 1) Backup current sessions. This is a standard precaution, b

Page 13

RADAR II 2.48 Release Notes Page 20 of 28 Rev B: October 16, 2000 Appendix I: System Memory Requirements Your system memory requirement can be de

Page 14

RADAR II 2.48 Release Notes Page 21 of 28 Rev B: October 16, 2000 Appendix II: RADAR II 64MB Patch This operating system patch is required if you

Page 15

RADAR II 2.48 Release Notes Page 22 of 28 Rev B: October 16, 2000 Appendix III: Approved SCSI Disk Drives The following audio drives are approved

Page 16

RADAR II 2.48 Release Notes Page 23 of 28 Rev B: October 16, 2000 Appendix V: Approved Backup Devices Approved DVD-RAM Drives: # Manufacturer

Page 17

RADAR II 2.48 Release Notes Page 24 of 28 Rev B: October 16, 2000 Appendix VI: Upgrading System Memory Fugu i430VX This motherboard shipped with

Page 18

RADAR II 2.48 Release Notes Page 25 of 28 Rev B: October 16, 2000 Appendix VII: Upgrading the System Processor Note: When you're swapping

Page 19

RADAR II 2.48 Release Notes Page 26 of 28 Rev B: October 16, 2000

Page 20

RADAR II 2.48 Release Notes Page 27 of 28 Rev B: October 16, 2000

Page 21

RADAR II 2.48 Release Notes Page 28 of 28 Rev B: October 16, 2000 Appendix VIII: RE-8 II Remote Control Key Map The shaded keys are new or have

Page 22

RADAR II 2.48 Release Notes Page 3 of 28 Rev B: October 16, 2000 Downgrade Procedure: If you wish to revert to a previous version of software, it

Page 23

RADAR II 2.48 Release Notes Page 4 of 28 Rev B: October 16, 2000 The “zoom solo” feature allows zooming to non-sequential track groupings. It can

Page 24

RADAR II 2.48 Release Notes Page 5 of 28 Rev B: October 16, 2000 Digital Track Assignment There is a new ‘DIG IN TRACKS‘ menu item under the

Page 25

RADAR II 2.48 Release Notes Page 6 of 28 Rev B: October 16, 2000 New Option to Show Backup Size An option to “SHOW BACKUP SIZE” has been added to

Page 26

RADAR II 2.48 Release Notes Page 7 of 28 Rev B: October 16, 2000 New Features Since Version 2.15: Simplified Disk Configuration The “24Trks/Disk”

Page 27

RADAR II 2.48 Release Notes Page 8 of 28 Rev B: October 16, 2000 RADAR Menu Structure The full menu tree is listed on the following pages. Chang

Page 28

RADAR II 2.48 Release Notes Page 9 of 28 Rev B: October 16, 2000 SET TIME & DATE UPGRADE SYSTEM MAIN/PROJ MENU: B

Commentaires sur ces manuels

Pas de commentaire